This ball joint is made from stainless steel and is used in both our Professional and ProPlus armatures. It has two pivot points. The balls are 6mm with an M3 threaded hole.

Includes:

• 2 Threaded balls
• 1 Threaded plate
• 1 Countersunk plate
• 1 C/S screw

As used in our Professional and ProPlus armatures, these fixed joints have one pivot point. The balls are 6mm with an M3 threaded hole.

Includes:

• 1 Threaded balls
• 1 Fixing component
• 1 Threaded plate
• 1 Countersunk plate
• 1 C/S screw

Stainless steel threaded balls which are used in our Professional and ProPlus Armatures. These balls have an M3 threaded hole and are sold in batches of 10.

Includes:

• 10 Threaded balls

These components are made from stainless steel and are used in our fixed joints. They have an M3 threaded hole.

Includes:

• 1 Fixing component

Made from stainless steel and includes two through M3 threaded holes. Used to make the "T" and "X" section on the Professional Armature.

Includes:

• 1 Universal joint

An excellent component allowing for the addition of rigging to your armature. The rigging block includes 4 M4 threaded holes into which out riggin system can be attached. Can be added to our Professional Armatures.

Includes:

• 1 Rigging block

Precision made stainless steel foot components complete with threaded tie-down rod.

Includes:

• 2 Foot components
• 1 Standard threaded tie-down system (shown below)

Standard threaded tie-down system as used on both our Professional and ProPlus Armatures.

Includes:

• 1 Tie-down rod
• 1 Wing nut

175mm stainless steel M3 threaded rod

Includes:

• 1 Threaded rod

The hands on our armatures have been designed to be easily replaced. These wire hands are used on our Standard and Professional Armatures but also compatible with our ProPlus Armatures too although you would need some additional tubing, available on the ProPlus components page.

Includes:

• 3 Metres 1mm wire
• 1 Metre 2.5mm heat shrink
• 2 Finger plates
• 2 Square brass tubes

ProPlus hands can be added to our Professional armatures, although you will need two additional threaded balls to be able to do so.

Includes:

• 2 Hand components
• 2 Threaded balls
• 2 Patched setscrews
• 6 M2 machine screws
• 3 Metres 1mm wire
• 1 Metre 2.5mm heat shrink
• 1 Allan key

0.7mm aluminium wire. The wire is specifically for animation, and heat shrink tubing allows maximum durability. These items are used in our ProPlus hands.

Includes:

• 3 metres of 0.7mm wire
• 1 metre of 2.5mm Heat Shrink

1mm aluminium wire. This wire is ideal for making any of our armature's hands. It is specifically for animation, is malleable and long lasting (Particularly when used with protective heat shrink tubing).

Includes:

• 45 metres of 1mm wire

Heat shrink tubing makes animation wire more durable, helping it last longer. It simply slides over the wire and then when heated shrinks to by as much as half it's original size, down to 1.25mm. Used on our armature's hands.

Includes:

• 1 metre of 2.5mm heat shrink tubing